This is a very cool project that is pretty easy to do. Keep in mind, you will have to do a very small amount of soldering on your precious PCB, so if you are not comfortable with a soldering iron, you might want to find someone who is. I have to give credit where credit is due. I got the idea to do this project from JHendrix. He told me that he was going to do it to his supergun, and how to go about it. I added the idea of the disconnect and switch location, which I am very happy with as it does not require any drilling. |
 |
You will need a soldering iron |
 |
Solder |
 |
20 Gauge hookup wire |
 |
Wire strippers |
 |
A Single Pole, Single Throw (SPST) switch or button. I used a Radio Shack p/n 275-324B. Make sure it is small enough to fit in the holes of your control panel if you don't want to do any drilling. |
 |
2 wire molex connector male and female |
 |
2 sets molex .093 pins for the above connector male and female |