It's all about the hardware
Home News Photos Downloads Tech Center Projects PCB Guide Product Reviews Parts Flyers MVS FAQ Links About Contribute Disclaimer

MVS Label Project

Hyper64 ST-V F3 Irem Madonna
Adding the AES BIOS to your MVS PCB
Optional Step
Page 1 Page 2 Page 3 Page 4

I like to use the Molex connectors so I can seperate the wiring for removing the PCB. If you don't want to do this, you can skip over the next few steps.

Cut the three wires just long enough to reach the edge of the PCB and add about 3 inches. Then crimp Male Molex pins on the end of all three wires.
Use a 3 pin Female connector, it does not matter what order the wires are in.
Do the same thing on one end of the wires you cut off, using the Female pins and Male Molex connector. Match up the wires.